$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Shift Rod Bushings
1 x ARP Ring Gear Bolts F25/F35
2 x 9000 High Performance Brake Line Kit '95-'98
1 x Exhaust manifold Stud Kit
2 x 9000 Intercooler ETS
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Open Air Intake 9000 93-98
2 x Flywheel Twin Disk 7.25in B2xx
1 x 9-5 High Performance Brake Line Kit
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Steering Coupler 9-3 99-02
2 x Brembo Kit 315mm Hawk HPS Pads
1 x Oil Cap 9-3SS "Ghost"
1 x 20th Viggen logo Shifter Top
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Oil Cap GM "HHR"
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Alu Hybrid Flywheel For NG900/9-3
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Head Bolt Washers
2 x Hood Emblem 9-3 SS/sc 03- All
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x BSR 9-5 2010-2011 V6 300Hp
1 x Brake Vac pump seals
1 x Mat Set Textile Jet Black 9-5 10-
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Forge Bypass Valve Cobalt/HHR TC
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Mat Set Textile Parchment 9-5 10-
1 x Weld Bungs -Taper- Race Only
1 x Optical Cable Connector (Onstar Delete)
1 x Intake Flange B2x4 T5
1 x Oil Cap 9-3ss V6 "Airplane"
1 x Aero Clutch Kit 9-5
1 x K&N Filter Service Kit
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x Crush Sleeve F35 F25
1 x Midpipe 2.8T XWD (4wd)
1 x 9-3 ng900 radio wires
1 x Injectors 175hp Stg3 (Set4)
$9,187.27
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail