$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Rear Camber Shims Kit 6pcs
2 x Cat back for Viggen 2.5in
6 x ARP Exhaust Manifold Stud kit Stainless
3 x Exhaust manifold Stud Kit
1 x Flex Pipe 900 94-98 9-3 99-02
7 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
2 x Exhaust Clamp Kit
4 x Viggen Fog Air Intake
4 x Oil Cooler Adaptor B2X5
3 x K&N Filter Service Kit
4 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x Shifter Mount Kit Cobalt/ HHR
1 x Oil Cap GM "HHR"
1 x Short Shifter HHR Cobalt F35 F40
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
2 x Head Stud Kit all 4cyl
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Fuel Pressure Regulator 4.0 bar
1 x Injectors Siemens 60lb 630cc (set 4)
2 x 20th Viggen logo Shifter Top
2 x c900 Performance Brake lines
2 x Replacement V6 Coolant Cap
1 x B207 Coolant Cap
1 x T7 Head Plug NGK
1 x 9000 Shifter Bushing Repair Kit
2 x PPC - Upgrade from stage 1 to stage 3
1 x SCNA Christmas Calendar
1 x Troll Head Plug
1 x Oil Pressure Switch
1 x Direct Ignition T7 Black
1 x Cabin Vent Fan
1 x Fuel Line Clip
2 x Spec Light Flywheel For 9-5 4cyl 99-09
1 x 9-5 Intercooler ETS
2 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Floormats BSR 9-5
2 x Adaptor Harness Handsfree 01-
1 x Cigarette Lighter
1 x Bulb Switch Light
1 x Rear spring perches Adjustable NG900/9-3
1 x 9-5 Shift Knobs Leather
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x 9-5 Textile Mats 98-07
2 x Steering Coupler 9-3 99-02
1 x Limit Strap Coilover Add On Kit
1 x Downpipe 2.8T XWD (4wd)
2 x ShortShift Kit 93ss
1 x Downpipe 2.8T FWD (2wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
3 x BSR Optiflow Intake 4cyl
2 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x Shifter Mount Kit 93ss
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
1 x Midpipe 2.8T XWD (4wd)
2 x Rear Pedestal Spoiler 9-3 SS
2 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Injectors 175hp Stg3 (Set4)
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Con Rods V6 2.8L 155.8mm
1 x BSR PPC 9-3 SS/SC Aero 2.8T V6 250hp
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
1 x Floormats BSR 9-3SS/SC
1 x 9-5 Open Air Prefilter
1 x v6 header flange
1 x Saab black Keychain
1 x PPC 3 Volvo Diagnostic System
1 x Hood Emblem 9-5 All
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x BSR 9-5 3.0T V6 200Hp
1 x Fog light 9-3 left 99-00
2 x 9-3 ng900 Hood Protection Strip
3 x Shift Rod Bushings
4 x T7 3.5 Bar Fuel Pressure Regulator
3 x T7 Injector Spacer Kit
1 x Turbo Conversion Pipe 900 9-3 T5
3 x Throttle Bend for T5 94-99
1 x Shifter Alignment Pins (Set 2)
1 x Intake Flange B2x4 T5
1 x Injectors Green Giant 42lb (set 4)
1 x Machined Control Arm Kit
3 x Clear Little Fender Blinkers Factory Saab
1 x Mat Set Textile Jet Black 9-5 10-
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Steering Rod Bushings NG900/93
1 x 4 Cyl 2.0 Coolant Tank
1 x Hood Emblem 9-3 SS/sc 03- All
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Brembo Brake Kit 315mm 9-3 SS
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Rear Engine Mount 4cyl
1 x Fog light Replacement Panels
1 x 9-3 99-02,03 CV Antenna Adaptor
1 x 9-3 ng900 radio wires
1 x Downpipe Hardware Kit
1 x Replacement Filter for Open air 9-3 T7
1 x Drop in Sport Filter 9-5
1 x 3 Point Hardware
1 x Ignition Coil 9-3SS 2.0t and 2.0T
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Front Rotors PAIR 285mm Plain (Code: AA)
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Coreganizer
1 x Fog light 9-3 Right 99-00
1 x Balance Shaft Tensioner Delete
1 x Replacement Flywheel Insert NG900/9-3
1 x Map/MAT sensor weld bung
$29,056.02
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail