$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x 9000 Shifter Bushing Repair Kit
1 x SCNA Christmas Calendar
1 x B207 Coolant Cap
4 x T7 Head Plug NGK
2 x 9-3 / 900 Uprated Suspension Bushings Inner
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x AEM Wideband Gauge Kit
1 x Fuel Pressure Regulator 4.0 bar
1 x Intake Flange B2x4 T5
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
3 x Basic Subframe Brace
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
3 x Exhaust manifold Stud Kit
3 x 4340 Connecting Rods B204 B235
2 x Headbolts (New Style)
2 x Head Stud Kit all 4cyl
2 x 9-5 Wheel 10-Spoke 16in.
2 x Midpipe 2.0T 07-11 FWD (2wd)
2 x Oil Filter Re-locator
1 x Rod Bearings only Pauter Rods
3 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Direct Ignition T7 Black
1 x Turbo Conversion Pipe 900 9-3 T5
1 x Mass Airflow Meter T7
1 x Fog light 9-3 left 99-00
1 x Clear Little Fender Blinkers Factory Saab
2 x Rear Camber Shims Kit 6pcs
1 x Direct Ignition T5 RED
1 x Throttle Bend for T5 94-99
3 x Downpipe Hardware Kit
1 x Remote Button NG900
1 x Fog light 9-3 Right 99-00
1 x T7 Injector Spacer Kit
2 x Floormats BSR 9-3 99-02 900 94-98
1 x Genuine Saab 4cyl Oil Filters
1 x 9-3/NG900 Shift Knobs Leather
4 x Rear Engine Mount 4cyl
1 x 9-5 Wheel 5-Spoke Twin 17in
2 x Replacement Filter for Open air 9-3 T7
2 x Adaptor Harness Handsfree 01-
2 x T7 3.5 Bar Fuel Pressure Regulator
3 x Viggen Fog Air Intake
2 x 20th Viggen logo Shifter Top
1 x 9-3SS Wheel 5-Spoke Low Split 17 in.
3 x 9-3 ng900 radio wires
1 x Steering Coupler 9-3 99-02
2 x 9-3 / 900 Uprated Front ARB Bushings
3 x Griffin logo Shifter Top
2 x Fuel Line Clip
1 x Exhaust Clamp Kit
2 x 9-3 Rear Ashtray
3 x Steering Rod Bushings NG900/93
1 x 9-3 99-02,03 CV Antenna Adaptor
3 x Flex Pipe 900 94-98 9-3 99-02
3 x 5d Rear Window repair kit 94-02 900/9-3/9-5
4 x Rear spring perches Adjustable NG900/9-3
1 x Antenna Plug NG900/9-3 hatchback
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Crank Vent Kit #6 T7 4cyl
1 x Machined Control Arm Kit
3 x Fog light Replacement Panels
1 x 9-3 /NG900 Grille
1 x 9-3 ng900 Hood Protection Strip
2 x Replacement Hardware Pack 6-Point
2 x Coreganizer
2 x Oil Cooler Adaptor B2X5
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
2 x 9000 Intercooler ETS
1 x Sparkplugs 9-3SS
3 x Open Air Intake 9000 93-98
1 x B207 Upper Radiator Coolant T
1 x 9-3 SS Akebono Rear Pads
5 x Shift Rod Bushings
1 x 3 Point Hardware
1 x Front Camber Adjustment Bolts
1 x Oil Cap GM "HHR"
2 x Crush Sleeve F35 F25
1 x Saab black Keychain
1 x Oil Cap 9-3SS V6 "Ghost"
1 x Alu Hybrid Flywheel For NG900/9-3
1 x V6 Tank Float - SparePart
1 x Troll Head Plug
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x Optical Cable Connector (Onstar Delete)
1 x Headlight Connector Repair Kit 9-3SS 9-5
1 x Upgrade Valve Springs T5 Cars
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Goodridge Brake Lines 9-3 SS / SC 03-
1 x Moog Ball Joint
2 x 9000 High Performance Brake Line Kit '95-'98
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Aluminum Flywheel For NG900/9-3
2 x Shifter Top Ghost Logo
1 x 9-5 Blend Flap Limit Lever 99-04
1 x Fog light Replacement Panels 99-01
1 x Rear Pedestal Spoiler 9-3 SS
1 x Cat Back Exh for 9000 CS, CSE AERO
1 x ARP Exhaust Manifold Stud kit Stainless
1 x K&N Filter Service Kit
1 x 9-5 286mm REAR Brembo Disk (1) See Descr.
1 x Downpipe 2.8T FWD (2wd)
2 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Balance Shaft Tensioner Delete
1 x MTF0063 Manual Gear oil
1 x Drop in Sport Filter 9-5
1 x BBS Center Cap for 9-2x RK small caps
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
1 x Injectors Siemens 80lb 875cc (set 4)
1 x c900 Performance Brake lines
1 x v6 2.8t SAI Delete Kit
1 x 9-5 Exhaust Flex Pipe Stainless
$23,535.55
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail