$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
5 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
1 x 9000 Shifter Bushing Repair Kit
4 x BSR Optiflow Intake 4cyl w SAI
1 x Replacement V6 Coolant Cap
1 x B207 Coolant Cap
2 x 3 Point Hardware
1 x SCNA Christmas Calendar
1 x Con Rods V6 2.8L 155.8mm
2 x T7 Head Plug NGK
2 x Short Shifter HHR Cobalt F35 F40
1 x Troll Head Plug
2 x Oil Cap GM "HHR"
1 x 9-3/NG900 Shift Knobs Leather
1 x Shifter Mount Kit Cobalt/ HHR
1 x Forge Bypass Valve Cobalt/HHR TC
2 x Clear Little Fender Blinkers Factory Saab
3 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x c900 Performance Brake lines
1 x Shifter Mount Kit 93ss
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x Injectors Siemens 60lb 630cc (set 4)
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
1 x Downpipe 2.8T FWD (2wd)
1 x 9-5 Rear Brake rotor See Description
1 x Aero Clutch Kit 9-5
1 x Antenna Plug NG900/9-3 hatchback
2 x 9-3 ng900 Hood Protection Strip
1 x Metal Steering Wheel Buttons
1 x Air Filter 06 version (All 9-5)
1 x 9-5 Wheel 10-Spoke 16in.
2 x 9-3 /NG900 Grille
2 x Adaptor Harness Handsfree 01-
1 x 9-3 ng900 radio wires
2 x PPC - Upgrade from stage 1 to stage 3
1 x Fog light Replacement Panels
1 x 9-3 Rear Ashtray
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Catback 2.5in Exh 900/9-3 94-02 Round Tip
1 x Turbo Conversion Pipe 900 9-3 T5
2 x 9-3 / 900 Uprated Front ARB Bushings
2 x T7 Injector Spacer Kit
2 x Basic Subframe Brace
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x Crush Sleeve F35 F25
2 x Fuel Line Clip
1 x Head Stud Kit all 4cyl
1 x Catback 2.5in Exh 9-3 99-02 Wide Oval Tip (NOT VIG)
1 x Replacement Filter for Open air 9-3 T7
1 x Exhaust manifold Stud Kit
2 x Flex Pipe 900 94-98 9-3 99-02
1 x MTF0063 Manual Gear oil
1 x 4340 Connecting Rods B204 B235
1 x Crank Vent Kit #6 T7 4cyl
1 x Balance Shaft Tensioner Delete
3 x Genuine Saab 4cyl Oil Filters
1 x Remote Button NG900
1 x Headbolts (New Style)
1 x JE Piston Rings 90.0mm 235/205
2 x ARP Exhaust Manifold Stud kit Stainless
2 x Rear Engine Mount 4cyl
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x Cat back for Viggen 2.5in
1 x Oil Filter Re-locator
3 x Rear Camber Shims Kit 6pcs
1 x Rear spring perches Adjustable NG900/9-3
1 x Direct Ignition T7 Black
2 x Steering Coupler 9-3 99-02
2 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Machined Control Arm Kit
1 x Mass Airflow Meter T7
1 x Rod Bearings only Pauter Rods
1 x Downpipe Hardware Kit
2 x Exhaust Clamp Kit
1 x Replacement Hardware Pack 6-Point
1 x Direct Ignition T5 RED
2 x Alu Hybrid Flywheel For NG900/9-3
1 x Aluminum Flywheel For NG900/9-3
1 x Transmission Nut F35 F25
1 x Quaife Differential 9-5 and Viggen (F35)
1 x Shifter Top Ghost Logo
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Slave Cyl
1 x Replacement Flywheel Insert NG900/9-3
2 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
2 x Shift Rod Bushings
1 x Head Bolt Washers
1 x BSR 9-5 2010-2011 V6 300Hp
1 x T7 3.5 Bar Fuel Pressure Regulator
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Intake Flange B2x4 T5
2 x 9-5 Aero Sill Protection
2 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x BSR Optiflow Intake 4cyl
1 x Oil Cooler Adaptor B2X5
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x Fog light Replacement Panels 99-01
2 x 9-5 Exhaust Flex Pipe Stainless
1 x Oil Cap 9-3SS V6 "Griffin"
1 x Front Camber Adjustment Bolts
1 x Floormats BSR 9-5
1 x Filter 9-5 Cabin Air
1 x Oil Pressure Switch
1 x Front Camber Adjustment Bolts
1 x Headlight Bulb H7 Longer Life
1 x 9-5 Textile Mats 98-07
1 x 9-5 Shift Knobs Leather
1 x Upgrade Valve Springs T5 Cars
1 x Moog Ball Joint
1 x 9-3 SS Akebono Rear Pads
1 x Viggen Front Brake Disk Pair 308mm
2 x Midpipe 2.8T FWD (2wd)
1 x Shifter Alignment Pins (Set 2)
1 x Brake Vac pump seals
1 x Throttle Bend for T5 94-99
1 x v6 header flange
$24,130.31
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail