$58.00 $55.10

ShortShift Kit 93ss
[0104305]

ShortShift Kit 93ss

Add to Cart

Date Added: Tuesday 17 April, 2012

by andrew core

Installed on an 2008 9-3 2.0T.

I didn't have to take the shift console out to cut the base, i was able to get the space to do it incar by removing both side trim pieces and the shifter housing. I used a hacksaw with a long blade to cut out the plastic.

I had trouble cutting the ball of the original shift base, it seems on the 08's the base is changed a bit, to cut on the long side of 5/8" means you have to file down some odd angles left from the curve before the ball. It took a bit of creative reshaping to get the short shift adaptor to fit properly.

On re-install I found the easiest method to pop the ball back in was to use a belt. I slid it through the side of the shifter base and underneath where the ball goes, pulled up on the belt, pushed down on the shifter and presto hassle free ball engagement.

I did have to readjust my shifter when everything was said and done, there is a pretty comprehensive step by step tutorial for this on this website http://www.genuinesaab.com/psi/files3/F40CableAdjust.pdf

I did unfortunately break the clip that holds the horizontal cable during the adjustment process, luckily it's a cheap part, and is only broken on one side and still holds so the car is still driveable.

The shifter doesn't shorter the throws that much, it's more noticeable for the odd number gears, but it does tighten up the patter and cleans up that dreaded 1-2 shift quite a bit. I also have the GS shift bushing reinforcement on the car, and that helps loads too. I figure the next logical step is to get the base bushings, as I will have to open up the area again to fix that clip.

Rating: 4 of 5 Stars! [4 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
2 x Universal / Special Request
2 x Moog Ball Joint
3 x Fuel Pressure Regulator 4.0 bar
2 x AEM Wideband Gauge Kit
2 x Injectors Siemens 60lb 630cc (set 4)
2 x c900 Performance Brake lines
3 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x Injectors Green Giant 42lb (set 4)
6 x PPC - Upgrade from stage 1 to stage 3
2 x Injectors Siemens 80lb 875cc (set 4)
4 x Clear Little Fender Blinkers Factory Saab
4 x Intake Flange B2x4 T5
3 x Head Bolt Washers
2 x IAT Weld Bung T5/Bosch
2 x T5 3.0 Bar Map Sensor Adaptor
4 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x SCNA Christmas Calendar
3 x Saab black Keychain
1 x Short Shifter HHR Cobalt F35 F40
1 x Oil Cap GM "HHR"
4 x Replacement V6 Coolant Cap
2 x T7 Head Plug NGK
2 x 9-5 Aero Sill Protection
1 x Basic Subframe Brace
2 x 9-5 Wheel 5-Spoke Twin 17in
2 x 9-3SS Wheel 5-Spoke Low Split 17 in.
2 x Shift Rod Bushings
1 x 9000 Intercooler ETS
1 x Adaptor Harness Handsfree 01-
1 x 9-5 Shift Knobs Leather
2 x Headbolts (New Style)
2 x BSR 9-5 260Hp 2006-
1 x Cat Back Exh for 9-5 Aero 04-, All 06-
1 x Air Filter 06 version (All 9-5)
1 x 9-5 Textile Mats 98-07
1 x Antenna Plug NG900/9-3 hatchback
1 x MTF0063 Manual Gear oil
2 x 9-3/NG900 Shift Knobs Leather
2 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x 9-5 Blend Flap Limit Lever 99-04
2 x Fog light 9-5 Aero 04-05, 06-08 All Left
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Sport Transmission Mount 9-3/900 (Automatic)
2 x Fog light 9-3 Right 99-00
2 x Fog light Replacement Panels
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x v6 header flange
1 x JE Piston Rings 90.0mm 235/205
1 x 9-3 /NG900 Grille
1 x 9-5 Rear Brake rotor See Description
1 x 9-3 ng900 Hood Protection Strip
1 x ATF Saab 3309 (Automatic 02->)
1 x 9-5 AERO 308mm Front Brake Rotor / Disk
1 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x PPC 3 Volvo Diagnostic System
1 x 9-5 Rear Brake rotor VENTED 300mm See Desc
1 x 9-5 Wheel 10-Spoke 16in.
2 x Hood Emblem 9-3 SS/sc 03- All
1 x BSR PPC 9-3 SS/SC 2.0T 210hp 2007-->
1 x Ignition Coil 9-3SS 2.0t and 2.0T
3 x Sparkplugs 9-3SS
1 x Headlight Connector Repair Kit 9-3SS 9-5
2 x Optical Cable Connector (Onstar Delete)
2 x 3 Point Hardware
2 x Shifter Mount Kit 93ss
2 x 4 Cyl 2.0 Coolant Tank
1 x Front Camber Adjustment Bolts
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x B207 Upper Radiator Coolant T
1 x ShortShift Kit 93ss
1 x BSR PPC 9-3 SS/SC TurboX and XWD 2.8T V6 280hp
3 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
1 x Brake Vac pump seals
1 x BSR PPC 9-3 SS/SC 2.0T 210hp XWD 09-
1 x BSR Optiflow Intake 4cyl
1 x BSR Optiflow Intake V6 2.8t
1 x Open Air Intake 9000 93-98
2 x Crush Sleeve F35 F25
1 x Injectors 175hp Stg3 (Set4)
1 x Metal Steering Wheel Buttons
2 x Map/MAT sensor weld bung
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x 20th Viggen logo Shifter Top
1 x Weld Bungs -Taper- Race Only
1 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x 9-3 / 900 Uprated Front ARB Bushings
1 x Hood Emblem 9-5 All
2 x Headlight Bulb H7 Longer Life
1 x Oil Filter Re-locator
1 x Fuel Line Clip
1 x Viggen Clutch Kit 99-02
1 x Turbo Bypass Valve
1 x Rear Rotors PAIR 292mm Plain (Code: BB)
1 x Rear Pedestal Spoiler 9-3 SS
1 x Genuine Saab 4cyl Oil Filters
1 x Mat Set Black Rubber 9-5 10-
1 x Upgrade Valve Springs T5 Cars
1 x V6 Tank Float - SparePart
1 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Rivetnuts Pair (2pcs)
1 x Fog light 9-5 Aero 04-05, 06-08 All Right
1 x BSR 9-5 Aero 250Hp 2004-2005 Stage E85
1 x Fog light Replacement Panels 99-01
1 x Troll Head Plug
1 x Ceramic Low Dust Brake Pads 9-3 SS
1 x Exhaust Clamp Kit
1 x Rear Rotors PAIR 278mm Plain (Code: BA)
1 x Crank Vent Kit #6 T7 4cyl
1 x Front Brake Pads 9-5 9-3 900 LOW DUST
1 x Throttle Body T7
1 x Rear Engine Mount 4cyl
1 x Rear Brake Pads 900 97-98, 9-3 99-02+ 03CV
1 x Rear Rotors PAIR 292mm XWD (Code: BC)
$24,411.35
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail