$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
1 x Limit Strap Coilover Add On Kit
1 x SCNA Christmas Calendar
1 x Con Rods V6 2.8L 155.8mm
1 x Replacement V6 Coolant Cap
2 x 9000 Shifter Bushing Repair Kit
2 x 3 Point Hardware
1 x B207 Coolant Cap
4 x Moog Ball Joint
2 x 20th Viggen logo Shifter Top
2 x 9-3 / 900 Uprated Suspension Bushings Inner
2 x 9-3 / 900 Uprated Front ARB Bushings
1 x 3pt Subframe Brace for 9-3 SS 2003-> 2wd
2 x Head Bolt Washers
1 x Injectors Siemens 80lb 875cc (set 4)
1 x c900 Performance Brake lines
3 x Header Flange 1/2in Blended Transition B2x4,B2x5
3 x Clear Little Fender Blinkers Factory Saab
2 x Injectors Green Giant 42lb (set 4)
2 x T5 3.0 Bar Map Sensor Adaptor
2 x IAT Weld Bung T5/Bosch
2 x PPC - Upgrade from stage 1 to stage 3
2 x Header Flange Stainless Blended Transition B2x4,B2x5
2 x Fuel Pressure Regulator 4.0 bar
1 x Rivetnuts Pair (2pcs)
1 x AEM Wideband Gauge Kit
2 x Universal / Special Request
2 x Injectors Siemens 60lb 630cc (set 4)
1 x Map/MAT sensor weld bung
1 x Shifter Alignment Pins (Set 2)
1 x MTF0063 Manual Gear oil
1 x ATF Saab 3309 (Automatic 02->)
2 x K&N Filter Service Kit
1 x Saab black Keychain
1 x Machined Control Arm Kit
1 x Crush Sleeve F35 F25
2 x Shift Rod Bushings
2 x PPC 3 Volvo Diagnostic System
2 x Rear Camber Shims Kit 6pcs
1 x Viggen Fog Air Intake
3 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x Weld Bungs -Taper- Race Only
1 x Turbo Conversion Pipe 900 9-3 T5
3 x Throttle Bend for T5 94-99
2 x Turbo to Downpipe Flange B207
1 x T7 Injector Spacer Kit
1 x v6oilcoolplate
1 x JE Piston Rings 90.0mm 235/205
1 x Balance Shaft Tensioner Delete
1 x Head Stud Kit all 4cyl
2 x v6 header flange
1 x Torque Mount Insert V6 Manual (XWD and FWD)
1 x Brembo Kit 315mm Sport Rotors Pair (For Saab)
1 x Oil Cap GM "HHR"
1 x 9000 Intercooler ETS
1 x Exhaust manifold Stud Kit
1 x Griffin logo Shifter Top
1 x Short Shifter HHR Cobalt F35 F40
1 x Alu Hybrid Flywheel For NG900/9-3
3 x ARP Exhaust Manifold Stud kit Stainless
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x Midpipe 2.0T 07-11 FWD (2wd)
1 x Midpipe 2.8T XWD (4wd)
1 x Shifter Mount Kit 93ss
1 x ShortShift Kit 93ss
1 x B207 Upper Radiator Coolant T
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
1 x Oil Cap 9-3SS "Ghost"
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
1 x Direct Ignition T7 Black
1 x Replacement Flywheel Insert NG900/9-3
1 x Air Filter 06 version (All 9-5)
2 x 9-5 Shift Knobs Leather
1 x Fog light Replacement Panels 99-01
1 x BSR 9-5 260Hp 2006-
1 x Sparkplugs 9-3SS
1 x Intake Flange B2x4 T5
1 x Fog light 9-5 Aero 04-05, 06-08 All Left
2 x Fuel Line Clip
1 x 9-5 Open Air Prefilter
1 x Oil Pressure Switch
1 x Adaptor Harness Handsfree 01-
2 x 9-5 Blend Flap Limit Lever 99-04
1 x Basic Subframe Brace
1 x JE Piston Ring (1cyl) 90.5mm 235/205/204
1 x 4340 Connecting Rods B204 B235
1 x Steering Coupler 9-3 99-02
1 x Rod Bearings only Pauter Rods
1 x Rear Engine Mount 4cyl
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x Downpipe Flange Assy. Stainless T25/Td04 to 3in
1 x Custom Brake Lines RR 300mm Kit
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Custom Brake Lines Brembo 315mm 9-3SS/SC
1 x Direct Ignition T5 RED
1 x 4 Cyl 2.0 Coolant Tank
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Filter 9-5 Cabin Air
$16,663.34
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail