$208.00 $156.00

Steering Rack Brace & Clamp Kit
[SRBK]

Steering Rack Brace & Clamp Kit

Add to Cart

Date Added: Thursday 07 April, 2011

by Steve Beisser

I bought a 2000 9-3 conv. 5 speed back in Sept. I love the car, but did not like some of the handling characteristics (major torque steer-which is really a problem when driving a 5 speed since only one hand is on the wheel when accelerating hard and winding through the gears, excessive body lean through turns, and cowel shake). I decided to buy this steering rack brace kit along with the rear sway bar. I ordered it on Monday and they arrived on Thursday. I just put in the steering rack brace and took it for a spin. All I can say is THANK YOU TALIAFERRO! The torque steer is GONE!. I do notice a slight more amount of road feel coming through the steering wheel, but i actually like this. Truth is, it is very minor and I only noticed it because I just installed the thing and was really trying to see what the differences were. The installation was not difficult (I was surprised that no instructions were provided but found the installation photos on this site). It took me about an hour to install. Some helpful hints. The upper strut brace gets in the way, so if you are planning on replacing that too it would make this job easier to remove the factory one, then install this rack brace, then install the new strut brace. I also found working on the lower bolt to be a bit of a challenge since you can't see it. One last thing to note. You do not have to remove the front right wheel as I have seen suggested in order to get at the nut on the bolt that goes through the wheel well, I just turned the wheel all the way to the left, which allowed me to put my 10 mm box wrench on the nut inside the wheel well and then reached over the fender to tighten the bolt with a 10 mm socket. Getting my torque wrench on the bolts was a challenge (upper strut brace gets in the way) but hopefully I got the torques OK. I will re-check after 100 miles as they suggest. Next on the list is the rear sway bar, then I plan on installing the upper strut brace and the 6 point sub frame brace. I plan on doing each upgrade one at a time and will report back the results. As far as this one goes - it's a no brainer. Everyone with this car needs to install this. In my opinion, it should be viewed as a safety feature (of course, it also increases the fun factor too!) It's hard to believe Saab let this model out of the factory without this.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
4 x Shifter Alignment Pins (Set 2)
4 x K&N Filter Service Kit
1 x Saab black Keychain
1 x Viggen Titanium KeyChain
1 x BSR Optiflow Intake Volvo S60 I T5 2001-2004
1 x T7 Head Plug NGK
1 x Header Flange 1/2in Blended Transition B2x4,B2x5
2 x PPC - Upgrade from stage 1 to stage 3
1 x Universal / Special Request
2 x Head Bolt Washers
1 x T5 3.0 Bar Map Sensor Adaptor
1 x Header Flange Stainless Blended Transition B2x4,B2x5
1 x Fuel Pressure Regulator 4.0 bar
1 x Rivetnuts Pair (2pcs)
4 x Shift Rod Bushings
2 x 9-5 Aero Sill Protection
1 x Sport Transmission Mount 9-5 (Manual) 1998-1999
1 x 9-5 Exhaust Flex Pipe Stainless
1 x Genuine Saab 4cyl Oil Filters
1 x Headlight Bulb H7 Longer Life
2 x Filter 9-5 Cabin Air
1 x Crank Vent Kit #6 T7 4cyl
1 x Oil Pressure Switch
2 x Mass Airflow Meter T7
2 x Fuel Line Clip
1 x Headbolts (New Style)
1 x Direct Ignition T7 Black
2 x Air Filter 06 version (All 9-5)
1 x 9-5 Open Air Prefilter
1 x Coolant Bypass Valve 9-5
2 x Cabin Vent Fan
1 x Downpipe Hardware Kit
1 x Sport Transmission Mount 9-3/900 (Automatic)
1 x Adaptor Harness Handsfree 01-
1 x 4 Cyl 2.0 Coolant Tank
1 x Open Air Intake 9000 93-98
1 x Clear Little Fender Blinkers Factory Saab
1 x Remote Button NG900
1 x 9-3/NG900 Shift Knobs Leather
1 x 9000 Intercooler ETS
2 x Basic Subframe Brace
1 x 9-5 Shift Knobs Leather
1 x 9-5 Textile Mats 98-07
1 x Downpipe 2.8T FWD (2wd)
1 x InjectorDynamics 725cc For 2.8V6 (Set6)
2 x B207 Coolant Cap
1 x Midpipe 2.8T FWD (2wd)
1 x Cat Back Exh for 9-3 SS 03-06, CV04-06 Stainless
2 x Forge Turbo Bypass Valve 9-3SS 2.0t 175hp
1 x PPC 3 Volvo Diagnostic System
1 x ATF Saab 3309 (Automatic 02->)
1 x Open Air Intake 9-3 00-02 and Viggen (All T7)
2 x 9-3, 9-5 Front Brake Rotor / Disk (Code: AD)
1 x Ignition Coil 9-3SS 2.8t and 2.8T
1 x Oil Cooler Adaptor B2X5
1 x 9-3 Rear Ashtray
1 x Front Camber Adjustment Bolts
1 x 5d Rear Window repair kit 94-02 900/9-3/9-5
1 x Forge Bypass Valve Cobalt/HHR TC
1 x Oil Cap GM "HHR"
1 x Forge Turbo Bypass Valve 9-3SS 2.0T 210hp
2 x v6oilcoolplate
1 x BSR Optiflow Intake 4cyl
1 x Oil Cap 9-3SS V6 "Griffin"
2 x v6 2.8t SAI Delete Kit
1 x Oil Cap 9-3SS V6 "Ghost"
1 x v6 header flange
2 x Turbo to Downpipe Flange B207
1 x Oil Cap 9-3SS "Ghost"
1 x Steering Rod Bushings NG900/93
1 x Performance Brake Line Kit NG900 94-98 9-3 99-02
1 x Viggen Front Brake Disk Pair 308mm
1 x Hawk HPS FRONT Pads 9-3 9-5 (900 97-98)
1 x Short Shifter NG900/9-3 94-02/9-5 (Outright Kit)
$11,047.45
Manufacturer Info
Taliaferro
Other products
Share Product
Share via E-Mail